POWER TRANSDUCER
♦ Micro controller based fully isolated design.
♦ Supplemented with 1, 2, Isolated outputs for one input option.
♦ AC/DC volt, AC/DC current,Millivolt.
♦ Frequency or load cell inputs available.
♦ 1.5 KV 3 Port Isolation & 0.25% Accuracy of FSD.
♦ Design as per requirement of IEC & CE Standard.
♦ 24VDC/220VAC/110VAC with 4 wire isolation.
♦ All Configurations and Calibration from front panel keypad.
♦ Micro controller based fully isolated design.
♦ Supplemented with 1,2,3,4 isolated outputs for one input option.
♦ AC / DC volt, AC / DC current, milliamp, millivolt, RTD,Thermocouple, Frequency or load cell inputs available.
♦ 1.5 KV 3 Port Isolation. & 0.25% Accuracy of FSD.
♦ Design make as per requirements of IEC Standerds & CE Standerds.
♦ 24VDC/220VAC/110VAC with 4 wire isolation.
♦ All Configurations and Calibration from front panel keypad.
♦ Highly communicative serial interface facility (RS 232 / 485).
♦ Transmitter loop power supply with current limit as standard.
T/C -K, J, R, S, E, N, T
RTD -Pt100, Cu53 ( 2 wire & 3 wire )
Currant -0 ~ 20mA DC, 4~20mA DC, 0-1/2/5 AMP AC
Voltage -DC: 0-75/200 mV DC, 0-1/5/10 VDC, 0-100/300/500 V DC, AC: 0-100/200/300/500 V AC
Resistence -0-50/500 Ω, 0-1/5/10 K Ω, Hz : 500 HZ, 0-1/25Khz
Transmitter power supply -10/12/24 V DC @ 30 mA max, isolated
Cold junction comp. & Sensor break ind. -Software base Automatic.
Response time -1 ms to 200 ms default 200 ms.
Accuracy -+/- 0.1 % of span for linear & RTD, +/-0.25 % for T/C
Input impedance ->330 K for Voltage, mV and T/C, 100 R for current
1.5 KV AC between -Input to output , Input to power, output to power, output to output (in case of multiple output)
Communication Protocol & method -Modbus RTU RS-485/RS-232 communication
Programmable parameter & Connectable number -Baud rate, Parity, Node address, stop bit & 0-256 unit
Programming of parameterse -Through computer software
Input /output range and calibrations -Through computer software and local hardware trim pot
Output type -0-20 mA, 4-20 mA, 0- 10V, 0-2V, 0-5V, 0-10V DC
Nos of Output -1 / 2 /3 / 4 all are isolated.
Dimensions & Mounting -As per order & Din rail mounted
Supply voltage & Power consumption -110/230 V AC, 50/60 Hz or 24 V DC 10 watt maximum
Operating ambient temperature and humidity -0~50 °C / Below 90%, non condensing
